This one package will cover all budding racers coming into on-road or off-road in the novice class. Get your skills up without getting into trouble with the CR215. A fixed timing 21.5 motor for the absolute raw beginner and the XPS Sport 100A ESC with led control card allows infinite tuning at your pit table, while you learn your craft.

Supplied in the package will be a 21.5 Club Racer motor, XPS Sport ESC, and an LED control card for tuning.

Specifications are listed below.

XPS Sport V3 (100A) Speed Control
Improvements based on XPS Sport V2:

. Is upgraded from 95A to 100A ampere spec and high grading FET to lower the hardware internal resistance with more output power and lower the speed control working temperature
. Support Ch3/Ch4 Aux Input signal to control different item function values (this parameter can be set from the LCD card directly)
. BEC: 6V/7.4V selection/max ~5A (this parameter can be set from the LCD card directly)
. Same PCB layout design with Radon Pro V4 with better stability and reliability
. Come with 12AWG high-density copper soft wire

. Is upgraded to Radon Pro V4 speed control firmware for default factory setup
. Compatible with Radon series speed control firmware

. Controls: Forward/Brake/Reverse
. Input Voltage: 2S-3S lipo
. BEC: 6V/7.4V selection/max ~5A
. Motor Limit: 6.5T or over
. Max current: ~100A per phase
. Size: ~41x32x18mm (without fan installed)
. Weight: ~42g (not include wiring and fan)
. Come with XPS V3 LED card or it can be used with a Radon LCD card(need to buy separately)

. Hardware design is the same as Radon Pro V4 series speed control except using plastic casing.
. Firmware, PC Software & LCD program card is compatible with Radon Pro V4.0 series speed control
. Ultra-smooth, Precise Throttle and Braking Control
. Compatible with Sensored/Sensorless Brushless Motors
. Data Analysis Capability(RPM, Low voltage, and ESC temperature)
. HotWire PC Interface for Advanced Programming and Updating
. Easily Programming through the LED card(included in the package)
. Built-in one-touch On/Off switch with LED
. Built-in Low voltage cut-off, Overheat protection, and signal loss protection

Cup Racer Brushless Motor(Sensor)
– Design Specification: Based on IFMAR/ROAR/EFRA/BRCA
– Motor Dimensions (Diameter x Length)  35.8mm x 51mm
– Shaft Diameter: 3.17mm
– Magnet Dimensions (Diameter x Length):  12.45mm x 24mm(6.5turn~9.5turn), 12.3mm x 24mm(10.5turn~21.5turn)
– Fix endbell with advanced timing already
– Weight: ~168g
– Recommended RC Model Car: 1:10 model car, Buggy, MINI Car

Additional information

Weight0.4 kg